LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2021 >> XF R-Dynamic SE >> Repair and Diagnosis >> External Pages >> Different car >> Section 93 (Engine - INGENIUM I4 2.0L Petrol -- XE (X760)) >> Engine - INGENIUM I4 2.0L Petrol >> Left Engine Mount >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different car, the 2018 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the engine mount to the vehicle.
  2. Lower the vehicle jack until the engine bracket rests on the engine mount.
  3. Install the engine mount to subframe bolts finger tight at this stage.
  4. Install the engine mount to engine bracket nut finger tight at this stage.
  5. Remove the vehicle jack.
  6. Fully tighten the engine mount to subframe bolts.

    Torque Specification: 47 Nm 

  7. Fully tighten the engine mount to engine bracket nut.

    Torque Specification: 60 Nm 

  8. Raise the vehicle on the lift to an appropriate working height.
  9. Connect the vacuum pipe to the engine mount.
  10. Install the air deflector.

    Refer to: Air Deflector .

  11. Lower the vehicle to the floor.
scientia non olet · About LEMON Manuals