Removal And Installation: Removal

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

WARNING:

Wait for a minimum of 1 minute after the engine has stopped before carrying out any repair to the fuel injection system.
Avoid flames, sparks or lighted substances.
Place the vehicle in a well ventilated, quarantined area and arrange ' No Smoking/Petrol Fumes' signs about the vehicle.

CAUTION: Before disconnecting or removing components, ensure the area around the joint faces and connections are clean. Plug open connections to prevent contamination.

NOTE:

Some variation in the illustrations may occur, but the essential information is always correct.
Some components shown removed for clarity.
Removal steps in this procedure may contain installation details.

All vehicles

Refer to: Diesel Fuel System Health and Safety Precautions .
Refer to: Fuel Tank Draining .
Raise and support the vehicle.
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
Refer to: Driveshaft - INGENIUM I4 2.0L Diesel .
WARNING: Be prepared to collect escaping fuel.
Torque Specification:

M8 nut 25 Nm
WARNING: Be prepared to collect escaping fuel.

Vehicles with fuel fired heater
WARNING: Be prepared to collect escaping fuel.

All vehicles
NOTE: Do not disassemble further if the component is removed for access only.

General Equipment: Transmission jack

Torque Specification: 25 Nm
Refer to: Fuel Level Sender .