LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2021 >> XF R-Dynamic SE >> Repair and Diagnosis >> External Pages >> Different car >> Section 90 (Fuel Tank & Lines - INGENIUM I4 2.0L Diesel -- XE (X760)) >> Fuel Tank And Lines - INGENIUM I4 2.0L Diesel >> Fuel Pump And Sender Unit >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
  • Wait for a minimum of 1 minute after the engine has stopped before carrying out any repair to the fuel injection system.
  • Avoid flames, sparks or lighted substances.
  • Place the vehicle in a well ventilated, quarantined area and arrange ' No Smoking/Petrol Fumes' signs about the vehicle.
CAUTION: Before disconnecting or removing components, ensure the area around the joint faces and connections are clean. Plug open connections to prevent contamination.
NOTE:
  • Some variation in the illustrations may occur, but the essential information is always correct.
  • Some components shown removed for clarity.
  • Removal steps in this procedure may contain installation details.
  1. Refer to: Diesel Fuel System Health and Safety Precautions .

    Refer to: Petrol and Petrol-Ethanol Fuel Systems Health and Safety Precautions .

  2. Refer to: Fuel System Pressure Release .
  3. Disconnect the battery ground cable.

    Refer to: Battery Disconnect and Connect .

  4. Refer to: Fuel Tank Draining .
  5. G11314726
  6. WARNING: Be prepared to collect escaping fuel.
    G11314727
  7. G11314728
  8. G11314729
  9. WARNING: The spilling of fuel is unavoidable during this operation. Make sure that all necessary precautions are taken to prevent fire and explosion.
    G11314730
  10. G11314731
  11. CAUTION: A new O-ring seal is to be installed.
    G11314732
scientia non olet · About LEMON Manuals