Mis-fuelling Procedure 3
WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
| SYMPTOM |
POSSIBLE CAUSES |
ACTION |
| Mis-fuelling issue. The diesel fuel tank has been filled with gasoline |
The vehicle has run for less than two minutes |
- Referring to the relevant section in the service information, drain the fuel tank
- The residual fuel from all removed parts needs to be checked for metal particles using a magnet
- Remove the fuel pump module and fuel level sensor
- Remove all traces of residual fuel within the fuel tank using clean absorbent cloth/paper
- Invert the fuel pump module and fuel level sensor to remove all traces of residual fuel
- Remove the fuel filter and discard
- Disconnect the fuel feed to the high-pressure fuel pump
- Flush all the fuel lines with clean diesel
- If no metal particles are detected, go to step 11
- If metal particles are present, go to procedure 4 and carry out step 3 to step 8
- Reassemble the fuel pump module and fuel level sensor to the fuel tank
- Install a new fuel filter
- Fully fill the fuel tank with clean diesel
- Road test the vehicle for at least 10 miles/16Km, checking for normal engine operation and no DTC'S
- Return the vehicle to the customer
|