LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2021 >> XF R-Dynamic SE >> Repair and Diagnosis >> External Pages >> Different car >> Section 80 (Transfer Case - Vehicles With: 8HP70 8-Speed Automatic Transmission AWD/8HP45 8-Speed Automatic Transmission AWD/8HP45 8-Speed Automatic Transmission RWD -- XE (X760)) >> Transfer Case - Vehicles With: 8HP70 8-Speed Automatic Transmission AWD/8HP45 8-Speed Automatic Transmission AWD/8HP45 8-Speed Automatic Transmission RWD >> Transfer Case Rear Output Seal >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
  1. G11314284

    Using the special tool, install a new input shaft seal.

    Special Tool(s):  307-520, JLR-307-695

  2. G11329597

    Apply a 1 mm diameter bead of sealant meeting specification to the output flange splines.

    Refer to SPECIFICATIONS 

  3. G11314285

    Install the rear output flange.

  4. G11314279

    Using the special tool, renew the rear output flange nut and seal.

    Special Tool(s):  205-053

    Renew Part: Transfer case rear output shaft flange nut. 

    Renew Part: Transfer case rear output shaft flange oil seal. 

  5. Install the driveshaft assembly.

    Refer to Driveshaft - INGENIUM I4 2.0L Petrol .

    Refer to Driveshaft - INGENIUM I4 2.0L Diesel .

  6. Check transfer case fluid level.

    Refer to: Transfer Case Fluid Level Check .

scientia non olet · About LEMON Manuals