LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2021 >> XF R-Dynamic SE >> Repair and Diagnosis >> External Pages >> Different car >> Section 80 (Transfer Case - Vehicles With: 8HP70 8-Speed Automatic Transmission AWD/8HP45 8-Speed Automatic Transmission AWD/8HP45 8-Speed Automatic Transmission RWD -- XE (X760)) >> Transfer Case - Vehicles With: 8HP70 8-Speed Automatic Transmission AWD/8HP45 8-Speed Automatic Transmission AWD/8HP45 8-Speed Automatic Transmission RWD >> Transfer Case Actuator >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
  1. CAUTION: Inspect the o-ring seals and replace if damaged or worn.

    Install the transfer case actuator.

    Torque Specification  : 10 Nm 

  2. Connect the connector.
  3. CAUTION: Do not fully tighten the bolts at this stage.

    Install the cross member.

  4. Install the cross member to transfer case retaining bolt.

    Torque Specification  : 110 Nm 

  5. CAUTION: Do not fully tighten the bolts at this stage.

    Fully tighten the cross member retaining bolts.

    Torque Specification  : 48 Nm 

  6. Connect the wiring harness.
  7. Install the heat shield.
  8. Fill the transfer case.

    Refer to: Transfer Case Draining and Filling .

  9. Connect the battery ground cable.

    Refer to: Battery Disconnect and Connect

    • Connect Jaguar Land Rover approved diagnostic equipment.
    • Clear any Diagnostic Trouble Codes (DTCs).
    • Start the diagnostic service function "transfer case-transfer case replacement".
    • Using the diagnostic tool, calibrate the component.
    • Clear any Diagnostic Trouble Codes (DTCs) after calibration and check for correct operation.
scientia non olet · About LEMON Manuals