LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2021 >> XF R-Dynamic SE >> Repair and Diagnosis >> External Pages >> Different car >> Section 72 (Supercharger Cooling - V6 S/C 3.0L Petrol -- XE (X760)) >> Supercharger Cooling - V6 S/C 3.0L Petrol >> Coolant Pump (G1829880) >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
  • This procedure contains illustrations showing certain components removed to provide extra clarity.
  1. Disconnect the startup battery ground cable.

    Refer to: Battery Disconnect and Connect .

  2. Raise and support the vehicle on a suitable 2 post lift.

    Refer to: Lifting .

  3. Drain the cooling system

    Refer to: Cooling System Draining and Vacuum Filling .

  4. Remove the left air cleaner outlet pipe.

    Refer to: Left Air Cleaner Outlet Pipe .

  5. Remove the left air cleaner.

    Refer to: Left Air Cleaner .

  6. G11307281
    • Disconnect the coolant pump electrical connector.
    • Release the 2 wiring harness clips.
  7. Disconnect the 2 coolant hose.
    CAUTION: Be prepared to collect escaping coolant.
    G11307282
  8. Remove the bolt and release the coolant pump.
    G11307283
scientia non olet · About LEMON Manuals