LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2021 >> XF R-Dynamic SE >> Repair and Diagnosis >> External Pages >> Different car >> Section 31 (Engine Ignition - V6 S/C 3.0L Petrol -- XE (X760)) >> Engine Ignition - V6 S/C 3.0L Petrol >> Ignition Coil-On-Plug >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different car, the 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Before disconnecting or removing the components, make sure the area around the joint faces and connections are clean. Plug open connections to prevent contamination.
NOTE:
  • Some variation in the illustrations may occur, but the essential information is always correct.
  • Some components shown removed for clarity.
  1. Disconnect the startup battery ground cable.

    Refer to: Battery Disconnect and Connect .

  2. Remove the engine cover.

    Refer to: Engine Cover - V6 S/C 3.0L Petrol .

  3. G11308059
  4. CAUTION: To prevent contamination, make sure to install the oil filler cap after removing the sound proofing pad.
    G11308060
  5. G11308061
  6. G11308062
  7. G11308063
  8. G11308064
  9. G11307689
  10. G11307690
scientia non olet · About LEMON Manuals