Thermostat Housing (G1998228): Removal

WARNING: This page is about a different car, the 2020 Jaguar XE and 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
This procedure contains illustrations showing certain components removed to provide extra clarity.

Raise and support the vehicle on a suitable 2 post lift.
Refer to: LIFTING
Remove the engine cover.
Refer to: ENGINE COVER - INGENIUM I4 2.0L PETROL
Partially drain the cooling system.
Refer to: COOLING SYSTEM PARTIAL DRAINING AND VACUUM FILLING
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Remove the Noise, Vibration and Harshness (NVH) pad.
CAUTION:
- Be prepared to collect escaping coolant.
- Mark the position of the components prior to removal.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Release the coolant hoses.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Remove the coolant outlet hose from the thermostat housing.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Remove the coolant bypass hose from the thermostat housing.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Disconnect the electrical connectors.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Remove the thermostat housing.