DTC P0615-4B: Starter Relay "A" Circuit - Over temperature: Action
WARNING: This page is about a different car, the 2020 Jaguar XE and 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
- Vehicle Conditions to Enable DTC Setting Strategy
- Continuous monitor
- Prioritized Checks to Perform
- Refer to the electrical circuit diagrams and check the starter motor relay circuit for short circuit to ground, short circuit to power, open circuit, high resistance. Check the electrical connectors for evidence of water ingress. Check the terminals for damage and corrosion. Repair the wiring harness as necessary
- Install a new starter motor relay
- Refer to the electrical circuit diagrams and check the powertrain control module power and ground circuits for open circuit, high resistance. Check the electrical connectors for evidence of water ingress. Check the terminals for damage and corrosion. Repair the wiring harness as necessary
- Using the Jaguar Land Rover approved diagnostic equipment, run application - ECU Diagnostics/Powertrain Control Module (PCM)/Update ECU
- Using the Jaguar Land Rover approved diagnostic equipment, run application - ECU Diagnostics/Powertrain Control Module (PCM)/Clear Diagnostic Trouble Code(s). Retest. If the fault persists, install a new powertrain control module: Run application - ECU Diagnostics/Powertrain Control Module (PCM)/Replace ECU