FLEXPLATE (G1921204): Installation

WARNING: This page is about a different car, the 2019 Jaguar XF. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Under no circumstances should the flexplate retaining bolts be inserted into the crankshaft with the flexplate removed. Failure to follow this instruction will result in damage to the engine.

NOTE: Do not insert the bottoming tap more than the depth of the threaded holes (16 mm). Apply tape to the bottoming tap 16 mm from the end as a visual guide.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Using a suitable bottoming tap, clean out the threads.
- Using suitable brake cleaner, remove any foreign material from the threads.
NOTE:
- The flexplate will only locate in one position.
- Make sure that new flexplate bolts are installed.
Fig 1: Flexplate Tightening Sequence
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Install the flexplate.
- Install and tighten the bolts in the sequence illustrated.
  Renew Part: Flexplate bolts Quantity: 8 .
  
  Torque
  
  Stage 1: 30 Nm
  
  Stage 2: 120°
Remove the special tool.
Special Tool(s): JLR-303-1630
Install the charge air cooler mounting bracket.
Torque: 40 Nm
NOTE: Make sure the wiring harness is routed correctly.
- Remove the charge air cooler mounting bracket nuts.
  Torque: 12 Nm
- Secure the wiring harness clip.
- Connect the electrical connector.
- Secure the wiring harness clips.
Refer to: TRANSMISSION - INGENIUM I4 2.0L DIESEL RWD
Refer to: TRANSMISSION - INGENIUM I4 2.0L DIESEL AWD
Install the charge air cooler.
Refer to: CHARGE AIR COOLER