LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2021 >> XF R-Dynamic SE >> Repair and Diagnosis >> External Pages >> Different car >> Section 145 (Engine - INGENIUM I4 2.0L Diesel -- XF/(X260) ( 1 Of 3)) >> Engine - INGENIUM I4 2.0L Diesel (G1817138) >> General Procedures >> NVH Balance Shaft Test (G2410580) >> Check

NVH Balance Shaft Test (G2410580): Check

WARNING: This page is about a different car, the 2019 Jaguar XF. However, it is still accessible from the selected car via links, so may be relevant.
  1. DIAGNOSIS: 

    The diagnostics application must be installed on your machine, download the link at the top of the general procedure.

    Special Tool(s): JLR-IDU2-ROW 

  2. If the "Click here to launch the following diagnosis application: Nvh Balance" link fails to open, proceed to step  5.
  3. If the Inline Diagnostic Unit 2 (IDU2) application fails continue to replace the balance shafts. If the IDU2  application passes continue to the next step.

    Refer to: BALANCE SHAFT ASSEMBLY 

    • Remove the accessory drive belt and confirm if the engine noise can be heard?
    • If the noise is still present continue to step 5.
    • If the noise is no longer present continue diagnosis using the repair information.

      Refer to: ACCESSORY DRIVE

  5. Continue diagnosis with the engine noise diagnosis and testing procedure.

    Refer to: ENGINE NOISE - INGENIUM I4 2.0L DIESEL 

scientia non olet · About LEMON Manuals