Removal And Installation: Removal

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Before disconnecting any components, make sure the area is clean and free from foreign material. When disconnected all openings must be sealed.

NOTE:

- This procedure contains some variation in the illustration depending on the vehicle specification, but essential information is always correct.
- This procedure contains illustrations showing certain components removed to provide extra clarity.

Raise and support the vehicle on a suitable 2 post lift.
Refer to: Lifting .

General Equipment: Two-post lift
Drain the transmission fluid.
Refer to: Transmission Fluid Drain and Refill .
- Remove the 3 clips securing the lower fender splash shield to the vehicle body.
- Remove the front left lower fender splash shield.
Release the 2 transmission cooler tubes from the transmission cooler assembly.
CAUTION: Be prepared to collect escaping fluid.
Remove the bolt securing the transmission fluid cooler tubes to the oil pan assembly.
CAUTION:
- Be prepared to collect escaping fluid.
- - Make sure that the area around the component is clean and free of foreign material.
  - Remove and discard the O-ring seal.
Remove the bolt securing the transmission fluid cooler tubes to the transmission assembly.
Remove the transmission cooler tubes.
CAUTION: Be prepared to collect escaping fluid.