LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2021 >> XF R-Dynamic SE >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine - INGENIUM I4 2.0L Petrol -- XF/(X260) >> Engine - INGENIUM I4 2.0L Petrol (G2289429) >> Removal And Installation >> Continuous Variable Valve Lift Oil Temperature Sensor (G2148902) >> Installation

Continuous Variable Valve Lift Oil Temperature Sensor (G2148902): Installation

  1. CAUTION:
    • Do not touch the tip of the Continuous Variable Valve Lift (CVVL) oil temperature sensor.
    • Lubricate the threaded section of the Continuous Variable Valve Lift (CVVL) oil temperature sensor with clean engine oil.
    • Install and tighten the CVVL oil temperature sensor.

      Torque: 18 Nm 

    • Connect the electrical connector to the CVVL oil temperature sensor.
    • Install the breather pipe.
    • Connect the breather pipe.
  3. Install the engine cover.

    Refer to: ENGINE COVER - INGENIUM I4 2.0L PETROL .

scientia non olet · About LEMON Manuals