Electric Park Brake Release When The Vehicle Has No Electrical Power: Activation

- Install a new O-ring seal.
  Renew Part: Electric park brake actuator O-ring seal and bolt kit Quantity: 2.
- Install the EPB actuator to the brake caliper.
- Install and tighten the 2 new bolts.
  Torque : 8 Nm
- Connect the electrical connector.
Install the rear wheels and tires.
Refer to: WHEEL AND TIRE
Repeat the above procedure for the other side.
Connect the 12 V system.
Refer to: STARTUP BATTERY DISCONNECT AND CONNECT