Rear Shock Absorber (G2219848): Removal

NOTE:

This procedure contains illustrations for right side components, left side components are similar.
This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
This procedure contains illustrations showing certain components removed to provide extra clarity.

Raise and support the vehicle on a suitable 2 post lift.
Refer to: JACKING AND LIFTING .
Using Jaguar Land Rover approved diagnostic equipment, depressurize the air suspension system.
Refer to: AIR SUSPENSION SYSTEM DEPRESSURIZE AND PRESSURIZE .

General Equipment : Jaguar Land Rover approved diagnostic equipment
Remove the rear wheel arch liner.
Refer to: REAR WHEEL ARCH LINER .
NOTE: Vehicles equipped with adaptive shock absorbers only.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Disconnect the electrical connector.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Using a suitable stand, support the lower control arm.

General Equipment : Transmission jack
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Remove and discard the nut and bolt.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Remove and discard the 2 upper shock absorber nuts.
- Remove the shock absorber.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Note the position of the components.
CAUTION: Inspect the components, replace if damaged or worn.

NOTE: Only do the following step(s) if a new component is to be installed.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Remove and discard the upper shock absorber nut.
- Remove the shock absorber boot and upper bracket.
- Remove the washer.
- Remove the shock absorber bumper.