LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2021 >> I-Pace SE >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel And Console -- I-Pace/X590 >> Instrument Panel And Console (G2152327) >> Removal And Installation >> GLOVEBOX (G2202014) >> Removal

GLOVEBOX (G2202014): Removal

NOTE:
  • This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
  • This procedure contains illustrations showing certain components removed to provide extra clarity.
  1. G13925560Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
    • Open the glovebox.
    • Release the 2 lid check arms.
    • Release the glovebox lid damper cable.
    • Release the 2 glovebox lid lower hinges.
    • Remove the glovebox lid.
  2. CAUTION: Do not use excessive force to remove the component.
    G13925561Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
    • Release the 4 clips.
    • Release the plastic retainers.
    • Remove the trim panel.
  3. G13925562Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
    • Carefully release the 3 clips.
    • Release the plastic retainers.
    • Remove the trim panel.
  4. G13925563Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
    1. Release and disconnect the electrical connector.
    2. Remove the 9 bolts.
    3. Carefully release each side of the glovebox.
    4. Disconnect the glovebox cooling duct.
    5. Remove the glovebox case starting from the lower end of the component.
  5. NOTE: Only perform the following step(s) if a new component is to be installed.
    G13925564Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
    • Remove the glovebox switch.
    • Remove the 2 screws.
    • Remove the glove box lid damper.