GLOVEBOX (G2202014): Installation

NOTE: Only perform the following step(s) if the component was previously removed.
- Install the glovebox switch.
- Install the glove box lid damper.
- Install and tighten the 2 screws.
  Torque: 1.9Nm
- Reposition the glovebox.
- Connect the glovebox cooling duct.
- Connect and secure the electrical connector.
- Install and tighten the 9 bolts.
Torque: 2.2Nm
- Position the trim panel with the plastic retainer and the locator pins.
- Carefully secure the 3 clips.
CAUTION: Do not use excessive force to install the component.
- Position the trim panel with the plastic retainer and the locator pins.
- Secure the 4 clips.
- Position the glovebox lid.
- Secure the glovebox lid 2 lower hinges.
- Secure the damper cable to the glovebox arm.
- Close the glovebox lid.