Wheel Knuckle - Vehicles With: Coil Suspension (G2224833): Installation

NOTE: Only do the following step if a new wheel knuckle is to be installed.

Install the rear wheel bearing to the wheel knuckle.

Refer to: WHEEL BEARING .
WARNING: This step requires the aid of another technician.
CAUTION:
- Make sure that the wheel hub and halfshaft mating faces are clean and free of foreign material.
- This nut and bolt must be tightened with the vehicle at normal ride height.
- Install the wheel knuckle assembly.
- Install a new upper control arm nut and bolt.
Renew Part: Upper control arm retaining nut and bolt Quantity: 1 .

Torque

Stage 1: 60Nm

Stage 2: 60°
Install the rear spring.
Refer to: SPRING .
- Reposition the brake caliper wiring harness.
- Install and tighten the bolt.
Torque : 9Nm
CAUTION: Make sure that the components are clean, dry and free from corrosion and foreign material.
- Install the rear wheel speed sensor.
- Install the wiring harness.
- Install and tighten the 2 bolts.
Torque : 9Nm
- Install the brake disc heatshield.
- Install and tighten the 3 bolts.
Torque : 9Nm
Install the brake disc.
Refer to: BRAKE DISC .
CAUTION:
- Do not use air tools to tighten the halfshaft nut. Failure to follow this instruction may result in damage to the halfshaft.
- Make sure the halfshaft is correctly located in the wheel hub.
Install and fully tighten the halfshaft nut removed in the removal steps.

Torque : 170Nm
- Remove and discard the halfshaft nut.
- Install and tighten a new halfshaft nut.
Renew Part: Rear halfshaft nut Quantity: 1

Torque

Stage 1: 175Nm

Stage 2Loosen: 90°

Stage 3: 100Nm

Stage 4: 90°
Install the rear wheel and tire.
Refer to: WHEEL AND TIRE .