Lower Control Arm (G2214447): Removal

CAUTION: The suspension arm nuts and bolts must be tightened with the suspension arms in the normal ride position. Failure to follow this instruction may result in premature failure of the bush.

NOTE:

This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
This procedure contains illustrations showing certain components removed to provide extra clarity.

The following step(s) applies to:

All vehicles

Raise and support the vehicle on a suitable 2 post lift.
Refer to: JACKING AND LIFTING .
Remove the wheel and tire.
Refer to: WHEEL AND TIRE .

The following step(s) applies to:

Vehicles with coil suspension
Remove the spring.
Refer to: SPRING .

The following step(s) applies to:

Vehicles with air suspension
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Remove and discard the nut.
- Release the stabilizer bar link.
Remove the rear air spring.
Refer to: REAR AIR SPRING .
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Remove and discard the integral link nut and bolt.
- Reposition the integral links.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Remove and discard the lower control arm to wheel knuckle bolt.

The following step(s) applies to:

All vehicles
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Disconnect the suspension height sensor link.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Release the wheel speed sensor harness from the bracket.
- Remove the wheel speed sensor harness bracket.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Remove and discard the nut and bolt.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Remove and discard the nut and bolt.
- Remove the lower control arm.