LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2021 >> I-Pace HSE >> Repair and Diagnosis >> Suspension >> Electronic Suspension >> Vehicle Dynamic Suspension -- I-Pace/X590 >> Vehicle Dynamic Suspension (G2142708) >> Removal And Installation >> Rear Suspension Height Sensor (G2201097) >> Installation

Rear Suspension Height Sensor (G2201097): Installation

    • Install the suspension height sensor.
    • Install and tighten the bolt.

    Torque  : 10Nm 

  2. Install the suspension height sensor link arm.
  3. Connect the electrical connector
    • Install the rear undershield.
    • Install the clip.
    • Install and tighten the 9 bolts.

    Torque  : 7Nm 

  5. Install the rear wheel and tire.

    Refer to: WHEEL AND TIRE .

  6. Connect the startup battery ground cable.

    Refer to: 12V SYSTEM DISCONNECT .

  7. Using Jaguar Land Rover approved diagnostic equipment, calibrate the suspension ride height.

    General Equipment  : Jaguar Land Rover approved diagnostic equipment 

scientia non olet · About LEMON Manuals