LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2021 >> I-Pace HSE >> Repair and Diagnosis >> Suspension >> Electronic Suspension >> Vehicle Dynamic Suspension -- I-Pace/X590 >> Vehicle Dynamic Suspension (G2142708) >> Removal And Installation >> Air Suspension Control Module (G2207033) >> Installation

Air Suspension Control Module (G2207033): Installation

    • Install the air suspension control module.
    • Install and tighten the 3 nuts.

    Torque  : 7Nm 

  2. Connect the 5 electrical connectors.
    • Install the Quiescent Current Control Module (QCCM).
    • Install and tighten the 2 nuts.

    Torque  : 7Nm 

  4. Connect the 2 electrical connectors.
  5. Install the right loadspace side trim.

    Refer to: LOADSPACE SIDE TRIM PANEL .

  6. Connect the startup battery ground cable.

    Refer to: 12V SYSTEM DISCONNECT .

  7. If a new component has been installed, configure using Jaguar Land Rover approved diagnostic equipment.

    General Equipment  : Jaguar Land Rover approved diagnostic equipment 

scientia non olet · About LEMON Manuals