Door Window Motor Initialization (G2223940)

NOTE:

In addition to this repair information, the approved diagnostic tool can also be used to initialize the door window motor.
Make sure that the startup battery is fully charged before completing this procedure.
After completing the following actions, it is necessary to initialize each door window motor separately. This calibrates the one touch and anti-trap function correctly.

Turn on the ignition.
Operate the window control switch until the door window glass is in the fully closed position, continue to operate the window control switch for a further two seconds.
Release the window control switch.
Operate the window control switch in the closed position and continue to operate the window control switch for a further two seconds.
Operate the window control switch until the door window glass is in the fully open position (one-touch down).
To make sure the door window motor initialization has been completed correctly. Operate the window control switch, the door window glass should move to the fully closed position (one-touch up) automatically.
If the door window glass does not fully close automatically (one-touch up), repeat the complete procedure.
Operate the window control switch once to the close position.
- If multiple attempts have failed to initialize the door window motor, refer to the diagnosis and testing procedure using the approved Jaguar Landrover diagnostic tool. For additional information, refer to: GLASS, FRAMES AND MECHANISMS .
Repeat the door window motor initialization for each door window motor.