GLOVEBOX (G2202014): Removal
NOTE:
- This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
- This procedure contains illustrations showing certain components removed to provide extra clarity.
- Open the glovebox.
- Release the 2 lid check arms.
- Release the glovebox lid damper cable.
- Release the 2 glovebox lid lower hinges.
- Remove the glovebox lid.
-
CAUTION: Do not use excessive force to remove the component.
- Release the 4 clips.
- Release the plastic retainers.
- Remove the trim panel.
- Carefully release the 3 clips.
- Release the plastic retainers.
- Remove the trim panel.
- Release and disconnect the electrical connector.
- Remove the 9 bolts.
- Carefully release each side of the glovebox.
- Disconnect the glovebox cooling duct.
- Remove the glovebox case starting from the lower end of the component.
-
NOTE: Only perform the following step(s) if a new component is to be installed.
- Remove the glovebox switch.
- Remove the 2 screws.
- Remove the glove box lid damper.