Transfer Case Bush (G1895648): Installation
- CAUTION: Make sure the special tool is installed to the bush in the correct orientation.
Special Tool(s): JLR-307-698
Renew Part: Transfer case bush Quantity: 1.
-
NOTE: To aid installation, lubricate the bush with soapy water.
Using the special tools, install the transfer case bush half way into the transfer case and wait for 2 minutes.
Special Tool(s): JLR-307-698
Fully install the transfer case bush into the transfer case and wait for 2 minutes.
Special Tool(s): JLR-307-698
Release the special tools and wait for 2 minutes. Check that the bush is evenly installed with no more than a 1 mm gap between the faces of the bush and the transfer case. If the gap is more than 1 mm repeat installation step 3.
Special Tool(s): JLR-307-698
- Install the transfer case.
Refer to: TRANSFER CASE .
- Connect the battery ground cable.
Refer to: STARTUP BATTERY DISCONNECT AND CONNECT .