LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2021 >> F-Pace SVR >> Repair and Diagnosis >> Transmission >> Transfer Case >> Transfer Case - Vehicles With: 8HP70 8-Speed Automatic Transmission AWD/8HP45 8-Speed Automatic Transmission AWD/8HP45 8-Speed Automatic Transmission RWD -- F-Pace (X761) >> Transfer Case - Vehicles With: 8HP45 8-Speed Automatic Transmission AWD/8HP70 8-Speed Automatic Transmission AWD (G1904678) >> Removal And Installation >> Transfer Case Actuator (G1896055) >> Installation

Transfer Case Actuator (G1896055): Installation

  1. Install the transfer case actuator.

    Torque  : 10 Nm 

  2. Connect the connector.
  3. CAUTION: Do not fully tighten the bolts at this stage.

    Install the cross member.

  4. Install the cross member to transfer case retaining bolt.

    Torque  : 110 Nm 

  5. CAUTION: Do not fully tighten the bolts at this stage.

    Fully tighten the cross member retaining bolts.

    Torque  : 48 Nm 

  6. Connect the wiring harness.
  7. Install the heat shield.
  8. Fill the transfer case.

    Refer to: TRANSFER CASE DRAINING AND FILLING .

  9. Connect the battery ground cable.

    Refer to: STARTUP BATTERY DISCONNECT AND CONNECT .

    • Connect Jaguar Land Rover approved diagnostic equipment.
    • After the Autoscan completes, start ECU Diagnostics.
    • Select Transfer Case Control Module [TCCM].
    • Select ECU Functions.
    • Run the All Wheel Drive System - Pump Venting application.
    • Follow the instructions shown on the Jaguar Land Rover approved diagnostic equipment.
    • Clear any Diagnostic Trouble Codes (DTCs) after All Wheel Drive System - Pump Venting and check for correct operation.
scientia non olet · About LEMON Manuals