Transfer Case Draining And Filling (G1908027): Filling
- NOTE: Make sure that all the component mating faces are clean.
Install the new drain plug.
Renew Part: Transfer case drain plug Quantity: 1.
Torque : 25 Nm
Install the drain plug.
Torque : 8 Nm
-
CAUTION: Make sure that the area around the component is clean and free of foreign material.NOTE: Do not discard the fill plug.
Remove the fill plug.
- Fill transfer case with the recommended fluid, until the fluid is level with bottom of filler/level plug hole. Refer to: SPECIFICATIONS .
-
NOTE: Make sure that all the component mating faces are clean.
Install the fill plug.
Torque : 8 Nm
-
CAUTION: Make sure that the area around the component is clean and free of foreign material.
Remove and discard the fill plug.
- Fill transfer case with the recommended fluid, until the fluid is level with bottom of filler/level plug hole. Refer to: SPECIFICATIONS .
- CAUTION: Make sure that the area around the component is clean and free of foreign material.
Install the new fill plug.
Renew Part: Transfer case fill plug Quantity: 1.
Torque : 25 Nm
- Install the Noise, Vibration and Harshness damper bracket.
- Install the 3 bolts.
Torque : 25 Nm
- Install the NVH damper nuts.
Torque: 45 Nm
- Install the caps.
- Install the NVH damper nuts.
- Install the air deflector.
Refer to: ENGINE UNDERSHIELD - INGENIUM I4 2.0L DIESEL/INGENIUM I4 2.0L PETROL/TDV6 3.0L DIESEL/V6 S/C 3.0L PETROL .
-
- Drive the vehicle for approximately 1 Km (0.6 miles).
- Connect an approved battery support unit/power supply to the vehicle.
- Connect the approved Land Rover diagnostic equipment.
- Check for Transfer Case Control Module (TCCM) software updates.
- Update TCCM software if required.
- With the engine running perform a diagnostic service function.
- Disconnect the approved diagnostic equipment.
- Disconnect the approved battery support unit/power supply from the vehicle.