Transmission To Power Transfer Unit Connecting Sleeve Seal (G2011756): Removal

NOTE:

This procedure contains some variation in the illustration depending on the vehicle specification, but essential information is always correct.
This procedure contains illustrations showing certain components removed to provide extra clarity.

Raise and support the vehicle on a suitable 2 post lift.
Refer to: LIFTING .
Remove the transfer case.
Refer to: TRANSFER CASE .
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Using a center punch and hammer, pierce a hole in the seal at the 12 O'clock position.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Screw a 2.5 x 15 mm self-tapping screw, a maximum of 2 turns into the input shaft seal and remove the seal using a suitable tool.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Clean the seal register and thoroughly inspect for damage.
NOTE: If equipped.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Remove and discard the breather.