Transfer Case Rear Output Seal (G2011758): Removal

NOTE:

This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
This procedure contains illustrations showing certain components removed to provide extra clarity.

Raise and support the vehicle on a suitable 2 post lift.
Refer to: LIFTING .
Remove the rear driveshaft.
Refer to: DRIVESHAFT - TDV6 3.0L DIESEL/V6 S/C 3.0L PETROL .

Refer to: DRIVESHAFT - INGENIUM I4 2.0L DIESEL .

Refer to: DRIVESHAFT - INGENIUM I4 2.0L PETROL .
CAUTION:
- Discard the nut.
- Discard the seal.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Using the special tool to secure the output flange in position, remove and discard the rear output flange nut and the rear output flange seal.

Special Tool(s): 205-053
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Using a suitable tool, remove the output flange.
WARNING: Be prepared to collect escaping oil.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Using a suitable tool carefully remove and discard the oil seal.
CAUTION: Make sure that the Jaguar approved cleaning fluid (Loctite™ 7063) is used to clean the mating face

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Make sure to thoroughly clean the output flange splines.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Clean the seal register and thoroughly inspect for damage.