LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2021 >> F-Pace SVR >> Repair and Diagnosis >> Transmission >> Manual Trans >> Transfer Case - Vehicles With: 6S45 6-Speed Manual Transmission RWD/6S45 6-Speed Manual Transmission AWD -- F-Pace (X761) >> Transfer Case - Vehicles With: 6S45 6-Speed Manual Transmission AWD/6S45 6-Speed Manual Transmission RWD (G1904679) >> Removal And Installation >> Transfer Case Actuator (G2011754) >> Installation

Transfer Case Actuator (G2011754): Installation

  1. CAUTION: Install new O-ring seals.

    Install the transfer case actuator.

    Renew Part: Transfer case actuator O-ring seals  Quantity: 1. 

    Torque  : 10 Nm 

  2. Connect the connector.
  3. CAUTION: Do not fully tighten the bolts at this stage.

    Install the cross member.

  4. Install the cross member to transfer case retaining bolt.

    Torque  : 110 Nm 

  5. CAUTION: Do not fully tighten the bolts at this stage.

    Fully tighten the cross member retaining bolts.

    Torque  : 48 Nm 

  6. Connect the wiring harness.
  7. Install the heat shield.
  8. Fill the transfer case.

    Refer to: TRANSFER CASE DRAINING AND FILLING .

  9. Connect the battery ground cable.

    Refer to: STARTUP BATTERY DISCONNECT AND CONNECT .

    • Connect Jaguar Land Rover approved diagnostic equipment.
    • Clear any Diagnostic Trouble Codes (DTCs).
    • Start the diagnostic service function "transfer case-transfer case replacement".
    • Using the diagnostic tool, calibrate the component.
    • Clear any Diagnostic Trouble Codes (DTCs) after calibration and check for correct operation.
scientia non olet · About LEMON Manuals