Tie Rod - V8 S/C 5.0L Petrol (G2263805): Installation
- CAUTION: The components must be hand tightened only at this stage.
- Install the tie-rod.
- Install and tighten the new tie-rod nut and bolt to the rear subframe.
Renew Part: Toe link to subframe nut and bolt Quantity: 1 .
Torque
Stage 1: 60 Nm
Stage 2: 90°
- CAUTION: The components must be hand tightened only at this stage.
- Install and tighten the new tie-rod nut and bolt to the wheel knuckle.
Renew Part: Tie-rod nut and bolt Quantity: 1 .
Torque
Stage 1: 80 Nm
Stage 2: 60°
- Install and tighten the new tie-rod nut and bolt to the wheel knuckle.
- Using the Jaguar Land Rover (JLR) approved 4 wheel alignment equipment, check the wheel alignment and adjust if required.
Refer to: WHEEL ALIGNMENT