Thermostat Housing (G2323060): Installation

WARNING: This page is about a different car, the 2023 Jaguar F-Pace and 2022 Jaguar F-Pace. However, it is still accessible from the selected car via links, so may be relevant.

- Install the new O-ring seal.
  Renew Part: Thermostat housing seal(s) Quantity: 1 .
- Install the thermostat housing.
- Install and tighten the 2 bolts.
  Torque : 12 Nm
Connect the coolant hose.
Install the wiring harness clip.
- Install the coolant hose.
- Install the 2 clamps.
Connect the 2 coolant hoses.
Connect the electrical connector.
- Install the wiring harness clip.
- Install the wiring harness into the clip.
- Install the A/C compressor bracket.
- Install and tighten the 4 bolts.
  Torque : 25 Nm
- Install the A/C pipe.
- Install and tighten the bolt.
  Torque : 9 Nm
Install the A/C compressor.
Refer to: AIR CONDITIONING COMPRESSOR - INGENIUM I6 3.0L PETROL .
Vacuum fill the cooling system.
Refer to: COOLING SYSTEM PARTIAL DRAINING AND VACUUM FILLING .
Connect the startup battery ground cable.
Refer to: STARTUP BATTERY DISCONNECT AND CONNECT .