LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2021 >> F-Pace SVR >> Repair and Diagnosis >> Engine Mechanical >> Cooling System (Mechanical) >> Engine Cooling - V8 S/C 5.0L Petrol -- F-Pace (X761) >> Engine Cooling - Vs S/C 5.0L Petrol (G2278138) >> Removal And Installation >> Rear Coolant Manifold (G2368733) >> Installation

Rear Coolant Manifold (G2368733): Installation

  1. NOTE: This step is only required if new components are not installed.

    Install 2 new O-ring seals to the rear coolant manifold.

    Renew Part: Cylinder block coolant outlet O-ring seals  Quantity: 2. 

    • Install the rear coolant manifold.
    • Install the rear coolant manifold to the coolant pump intake pipe.
    • Install and tighten the 4 bolts.

      Torque  : 9 Nm 

  3. Install the 2 wiring harness clips. 
    • Connect the 2 electrical connectors.
    • Install the wiring harness clip.
    • Connect the rear coolant manifold left hose.
    • Install the coolant hose clip.
  6. Connect the rear coolant manifold right hose.
    • Reposition the wiring harness into the correct location.
    • Install and tighten the 2 bolts.

      Torque  : 9 Nm 

    • Connect the symposer outlet hose.
    • Install and tighten the bolt.

      Torque  : 9 Nm 

  9. Install the engine cover.

    Refer to: ENGINE COVER - V8 S/C 5.0L PETROL (G2264506) .

  10. Vacuum fill the coolant system.

    Refer to: COOLING SYSTEM PARTIAL DRAINING AND VACUUM FILLING .

scientia non olet · About LEMON Manuals