Pinpoint Test A: Clutch Slippage

A1: TEST CLUTCH SLIPPAGE
1. Chock the wheels and apply the parking brake
2. Start the engine and engage 4th gear
3. Increase the engine speed to approximately 2000 rpm
4. Release clutch pedal slowly
  Does the engine stall when the clutch pedal is fully released?
  
  Yes
  
  Clutch performing normally
  
  No
  
  GO to A2.
A2: TEST CLUTCH FOR CLEARING
1. Start the engine
2. Fully depress the clutch pedal and partially engage reverse gear. Slowly release the clutch pedal until a grating noise is heard and then depress the clutch slowly until the grating stops
3. Measure the distance between the clutch pedal and the vehicle floor
  Is the measurement between 25 mm and 45 mm?
  
  Yes
  
  GO to A3
  
  No
  
  Check the clutch cover assembly. GO to PINPOINT TEST B .
A3: TEST FULL PEDAL TRAVEL
1. Measure the clutch pedal distance between from fully released and fully depressed
  Is the measurement between 140 mm and 150 mm?
  
  Yes
  
  GO to A4
  
  No
  
  Check clutch pedal for obstructions. Rectify as necessary
A4: TEST CLUTCH PEDAL
1. Check the clutch pedal shaft for lubrication
  Is the clutch pedal shaft sufficiently lubricated?
  
  Yes
  
  Check the clutch cover assembly. GO to PINPOINT TEST B .
  
  No
  
  Lubricate the clutch pedal shaft