Upper Control Arm - V8 S/C 5.0L Petrol (G2263806): Installation

Install the wiring harness brackets to the upper control arm.
- Install the upper control arm.
- Install and tighten the new upper control arm nuts and bolts to the subframe.
  Renew Part: Rear suspension upper arm to subframe nut and bolt Quantity: 1 .
  
  Torque
  
  Stage 1: 60 Nm
  
  Stage 2: 60°
- Install and tighten the new upper control arm nuts and bolts to the wheel knuckle.
  Renew Part: Rear upper arm to wheel knuckle nut and bolt Quantity: 1
  
  Torque
  
  Stage 1: 60 Nm
  
  Stage 2: 60°
- Install the brake pad wiring harness to the upper control arm.
- Install the parking brake wiring harness to the upper control arm.
- Remove the transmission jack.
- Install the wheel and tire.
  Refer to: WHEEL AND TIRE - V8 S/C 5.0L PETROL
Using the Jaguar Land Rover (JLR) approved 4 wheel alignment equipment, check the wheel alignment and adjust if required.
Refer to: WHEEL ALIGNMENT