Rear Stabilizer Bar Link - INGENIUM I4 2.0L Diesel/INGENIUM I4 2.0L Petrol/TDV6 3.0L Diesel/V6 S/C 3.0L Petrol (G1899820): Removal

NOTE:

Some variation in the illustrations may occur, but the essential information is always correct.
Some components shown removed for clarity.
Removal steps in this procedure may contain installation details.

Raise and support the vehicle with a suitable 2 post lift.
Refer to: LIFTING
Remove the rear wheel for access.
Refer to: WHEEL AND TIRE - INGENIUM I4 2.0L DIESEL/INGENIUM I4 2.0L PETROL/TDV6 3.0L DIESEL/V6 S/C 3.0L RETROL (G1967109)
CAUTION:
- Use a wrench on the hexagon provided to prevent the ball joint rotating.
- Discard the nuts.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Remove the rear stabilizer bar link and nuts.