Rear Stabilizer Bar - INGENIUM I4 2.0L Diesel/INGENIUM I4 2.0L Petrol/TDV6 3.0L Diesel/V6 S/C 3.0L RETROL (G1899819): Removal

NOTE:

Some variation in the illustrations may occur, but the essential information is always correct.
Some components shown removed for clarity.
Removal steps in this procedure may contain installation details.

WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.

Raise and support the vehicle with a suitable 2 post lift.

General Equipment: 2 post lift
Remove the rear subframe for access.
Refer to: REAR SUBFRAME - INGENIUM I4 2.0L DIESEL/INGENIUM I4 2.0L PETROL/TDV6 3.0L DIESEL/V6 S/C 3.0L PETROL
NOTE: The stabilizer bar bushes are bonded in place and do not separate from the bar

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Remove and discard the rear stabilizer bar link retaining nuts.
- Remove the rear stabilizer bar and retaining bolts.