Lower Control Arm - V8 S/C 5.0L Petrol (G2263802): Installation

CAUTION: Nut and bolts must be tightened with vehicle at normal ride height.

- Install the height sensor bracket to the lower control arm.
- Install and tighten the bolt.
  Torque: 9 Nm
- Install the 2 wiring harness brackets to the lower control arm.
- Install and tighten the 2 bolts.
  Torque: 9 Nm
- Install the rear lower control arm to the subframe.
- Install and tighten the new nut and bolt.
  Renew Part: Rear lower control arm nut and bolt Quantity: 1 .
  
  Torque
  
  Stage 1: 110 Nm
  
  Stage 2: 360°
- Install and tighten the new bolt.
  Renew Part: Lower control arm bolt(s) Quantity: 1
  
  Torque
  
  Stage 1: 110 Nm
  
  Stage 2: 360°
Install the spring.
Refer to: SPRING - INGENIUM I4 2.0L DIESEL/INGENIUM I4 2.0L PETROL/TDV6 3.0L DIESEL/V6 S/C 3.0L PETROL
Using Jaguar Land Rover (JLR) approved 4 wheel alignment equipment, check the wheel alignment and adjust if required.
Refer to: WHEEL ALIGNMENT