Lower Arm - INGENIUM I4 2.0L Diesel/INGENIUM I4 2.0L Petrol/TDV6 3.0L Diesel/V6 S/C 3.0L Petrol (G1899816): Removal
CAUTION:
- To avoid damage to the Constant Velocity joint (CV) or CV boot, do not allow the halfshaft to hang.
- Nuts and bolts must be tightened with vehicle at normal ride height.
NOTE:
- Some variation in the illustrations may occur, but the essential information is always correct.
- Some components shown removed for clarity.
- Removal steps in this procedure may contain installation details.
- Before replacing the Lower Arm, make sure to have followed the diagnosis and testing procedure.
Refer to: SUSPENSION ARMS
- Raise and support the vehicle on a suitable 2 post lift.
Refer to: LIFTING
- Remove the spring.
Refer to: SPRING - INGENIUM I4 2.0L DIESEL/INGENIUM I4 2.0L PETROL/TDV6 3.0L DIESEL/V6 S/C 3.0L PETROL
-
CAUTION:
- As the halfshaft is still installed extra care must be taken when positioning the jack stand to support the assembly. Failure to follow this instruction might disassemble or damage the CV.
- Take extra care when handling the assembly. Failure to follow this instruction might result in damage to the CV boot.
Using a suitable stand, support the wheel knuckle.
Torque: 9 Nm
Remove and discard the lower control arm bolt.
Renew Part: Lower control arm bolt(s) Quantity: 1 .
Torque
Stage 1: 110 Nm
Stage 2: 300°
Remove and discard the lower control arm nut and bolt.
Renew Part: Rear lower arm to subframe nut and bolt Quantity: 1 .
Torque
Stage 1: 110 Nm
Stage 2: 300°
Torque: 9 Nm