Cooling Module (G1818106): Removal
WARNING:
Cooling fans may continue to operate after the engine is turned off. They may also start to operate after the engine is turned off and continue operating for up to 10 minutes.
NOTE:
- Some variation in the illustrations may occur, but the essential information is always correct.
- Removal steps in this procedure may contain installation details.
- Some components shown removed for clarity.
-
WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
- Refer to: STARTUP BATTERY DISCONNECT AND CONNECT .
- Refer to: AIR CONDITIONING SYSTEM RECOVERY, EVACUATION AND CHARGING .
Torque: 3.5 Nm
Torque: 9 Nm
- Refer to: COOLING SYSTEM PARTIAL DRAINING AND VACUUM FILLING (G1885696)
- Refer to: ENGINE UNDERSHIELD - INGENIUM I4 2.0L DIESEL/INGENIUM I4 2.0L PETROL/TDV6 3.0L DIESEL/V6 S/C 3.0L PETROL .
-
CAUTION: Be prepared to collect escaping coolant.
-
CAUTION: Be prepared to collect escaping coolant.
-
CAUTION: Be prepared to collect escaping coolant.
Torque: 9 Nm
- Refer to: FRONT BUMPER - INGENIUM I4 2.0L DIESEL/INGENIUM I4 2.0L PETROL/TDV6 3.0L DIESEL/V6 S/C 3.0L PETROL .
-
CAUTION:
- Immediately cap all refrigerant lines to prevent ingress of dirt and moisture.
- Before disconnecting any components, make sure the area is clean and free from foreign material. When disconnected all openings must be sealed.
- A new O-ring seal is to be installed.
- Take care not to damage the O-ring seals during installation.
Torque: 20 Nm
-
CAUTION:
- Immediately cap all refrigerant lines to prevent ingress of dirt and moisture.
- Before disconnecting any components, make sure the area is clean and free from foreign material. When disconnected all openings must be sealed.
- A new O-ring seal is to be installed.
- Take care not to damage the O-ring seals during installation.
Torque: 20 Nm
-
NOTE: If equipped.
Torque
M12 Bolts: 90 Nm
M10 Bolts: 45 Nm
-
CAUTION: Make sure that the cooling module is supported for this step.
Torque: 9 Nm
-
CAUTION: Make sure that the cooling module is supported for this step.
Torque: 9 Nm