LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2021 >> F-Pace R-Dynamic S >> Repair and Diagnosis >> Engine Mechanical >> Cooling System (Mechanical) >> Engine Cooling - V6 S/C 3.0L Petrol -- F-Pace (X761) >> Engine Cooling - V6 S/C 3.0L Petrol (G1824624) >> Removal And Installation >> Coolant Rump (G1824662) >> Installation

Coolant Rump (G1824662): Installation

  1. CAUTION: Observe correct installation of the coolant pump to oil cooler tube o-ring seals. Failure to do so may result in coolant loss.
    G13880140Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Make sure that the coolant pump to oil cooler tube o-ring seals are correctly installed.

  2. CAUTION:
    • Make sure that the gaskets are correctly located.
    • Install all the bolts finger tight before final tightening.

    Install the coolant pump using new seals.

    Renew Part: Engine coolant pump gasket Quantity: 1. 

    Renew Part: Oil cooler to water pump O-ring seals Quantity: 1. 

    Torque: 12 Nm 

  3. Install the accessory drive belt tensioner.

    Torque: 47 Nm 

  4. Secure the clip and the coolant hose from the coolant pump.
  5. Install the thermostat bolt.

    Torque: 9 Nm 

  6. Install the coolant hose into the coolant pump.
  7. Install the accessory drive belt.

    Refer to: ACCESSORY DRIVE BELT .

  8. Fill the coolant system.

    Refer to: COOLING SYSTEM DRAINING AND VACUUM FILLING .

scientia non olet · About LEMON Manuals