Electric Park Brake Actuator - INGENIUM I4 2.0L Diesel/INGENIUM I4 2.0L Petrol/TDVS 3.0L Diesel/V6 S/C 3.0L Petrol (G1822087): Removal
NOTE:
Removal steps in this procedure may contain installation details.
- Connect the diagnostic tool and set the electronic park brake (EPB) to the maintenance position.
-
NOTE: This step is only required if the diagnostic tool is not available.
Refer to: ELECTRIC PARK BRAKE SERVICE MODE ACTIVATION AND DEACTIVATION .
-
WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
- NOTE: Remove and discard the O-ring seal.
Renew Part: Electric park brake actuator O-ring seal Quantity: 1
Torque: 8 Nm