Brake Master Cylinder And Brake Booster
| ITEM | DESCRIPTION |
|---|---|
| 1 | Brake fluid reservoir |
| 2 | Brake fluid level sensor electrical connector |
| 3 | Actuator rod |
| 4 | Brake vacuum sensor |
| 5 | Primary circuit outlet port |
| 6 | Service connector |
| 7 | Secondary circuit outlet port |
| 8 | Brake master cylinder |
The brake master cylinder and the brake fluid reservoir are attached to the front of the brake booster. They are located on the driver's side of the engine compartment. The brake master cylinder is a tandem design that supplies pressure to 2 independent (primary and secondary) hydraulic circuits. If a failure occurs in 1 hydraulic circuit, the remaining circuit will still operate effectively, although brake pedal travel and vehicle braking distances will increase.
The brake fluid reservoir is installed on top of the brake master cylinder and retains sufficient volume of brake fluid. An appropriate volume of brake fluid allows the normal system use and to compensate for the replenishment of the system as the brake pads wear.
A brake fluid level sensor is incorporated into the brake fluid reservoir.