Engine Cooling - INGENIUM I4 2.0L Petrol/INGENIUM I4 2.0L Petrol - PHEV (G2498297): Specifications

WARNING: This page is about a different car, the 2023 Jaguar F-Pace and 2022 Jaguar F-Pace. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Coolant must be collected into a clean container and can be reused if not contaminated.

TORQUE SPECIFICATIONS

ITEM	NM	LB-FT	LB-IN
Radiator Drain Plug	2	-	17
Coolant Bleed Screws	2	-	17
Coolant Expansion Tank Bolt	7	-	62
Auxiliary Radiator Bolts	7	-	62
Charge Air Radiator Coolant Pump Bolt	9	-	79
Cooling Fan and Motor Shroud Bolts	10	-	88
Coolant Pump Bolts	12	9	-
Coolant Pump Pulley Bolts	25	18	-
Radiator Mounting Bracket to Body Bolts	7	-	62
Radiator Mounting Bracket to Radiator Bolts	5	-	44
Thermostat Body Bolts	12	9	-
Coolant Bypass Hose Bolt	7	-	62
Block Heater	55	41	-
Coolant Degas Separator	12	9	-

LUBRICANTS, FLUIDS, SEALERS AND ADHESIVES

COOLANT	SPECIFICATION
Coolant	Texaco Extended Life Coolant (XLC) or any glycol based engine coolant containing no methanol with only Organic Acid Technology (OAT) corrosion inhibitors
Coolant concentration - Will provide frost protection to -40°C (-40°F)	50% (+10%/-0%)
Specific gravity of coolant at 20°C (68°F), to protect against frost down to -40°C (-40°F)	1.068

CAPACITIES

ITEM	CAPACITY (LITERS/PINTS/US QUARTS)
Cooling system capacity	14.7/25.8/15.5
Drain volume	7/12.3/7.4
Cooling system capacity Plug-in Hybrid Electric Vehicle (PHEV)	16.8/29.5/17.7
Drain volume PHEV	7.55/13.3/8

GENERAL SPECIFICATION

ITEM	SPECIFICATION
Cooling Fan	400 W
Cooling System Type	Pressurized, thermostatically controlled with remote header tank
Cooling System Type	Pressurized with integrated level sensor
Expansion Tank	140 kPa
Pressure Cap Rating	Crossflow 27 mm core with integrated drain plug
Thermostat	Wax element (heated)
Starts To Open	95°C (203°F)
Fully Open	108°C (226°F)