LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2021 >> F-Pace Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 145 (Engine Cooling - INGENIUM I4 2.0L Petrol/INGENIUM I4 2.0L Petrol PHEV -- F-Pace/X761) >> Engine Cooling - INGENIUM I4 2.0L Petrol/INGENIUM I4 2.0L Petrol - PHEV (G2498297) >> Removal And Installation >> Electric Cooling Fan And Shroud (G1998225) >> Installation

Electric Cooling Fan And Shroud (G1998225): Installation

WARNING: This page is about a different car, the 2023 Jaguar F-Pace and 2022 Jaguar F-Pace. However, it is still accessible from the selected car via links, so may be relevant.
  1. NOTE: This step is only required if previously removed.
    • Install the water pump.
    • Torque  : 9 Nm 
    • Install the cooling fan motor and shroud.
    • Torque  : 10 Nm 
  3. Attach the clips to the cooling fan motor and shroud.
  4. Connect the coolant hoses.
  5. Install the dirty air duct.
  6. Install the vent hose.
  7. Install the charge air radiator.

    Refer to: CHARGE AIR COOLER (G1998338) .

  8. Vacuum fill the cooling system.

    Refer to: COOLING SYSTEM PARTIAL DRAINING AND VACUUM FILLING (G1998221)  .

  9. Connect the startup battery ground cable.

    Refer to: STARTUP BATTERY DISCONNECT AND CONNECT .

scientia non olet · About LEMON Manuals