LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2021 >> F-Pace Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 145 (Engine Cooling - INGENIUM I4 2.0L Petrol/INGENIUM I4 2.0L Petrol PHEV -- F-Pace/X761) >> Engine Cooling - INGENIUM I4 2.0L Petrol/INGENIUM I4 2.0L Petrol - PHEV (G2498297) >> Removal And Installation >> Block Heater (G2033416) >> Installation

Block Heater (G2033416): Installation

WARNING: This page is about a different car, the 2023 Jaguar F-Pace and 2022 Jaguar F-Pace. However, it is still accessible from the selected car via links, so may be relevant.
  1. CAUTION: Replace the gasket if it is worn.
    • Install the gasket.
    • Install and tighten the block heater.

      Torque  : 55 Nm 

  2. Connect the electrical connector.
  3. Install the generator.

    Refer to: GENERATOR (G2027796) .

  4. Vacuum fill the cooling system.

    Refer to: COOLING SYSTEM PARTIAL DRAINING AND VACUUM FILLING (G1998221)  .

  5. Connect the startup battery ground cable.

    Refer to: STARTUP BATTERY DISCONNECT AND CONNECT .

scientia non olet · About LEMON Manuals