Active Grille Air Shutter (G2340170): Installation

WARNING: This page is about a different car, the 2023 Jaguar F-Pace and 2022 Jaguar F-Pace. However, it is still accessible from the selected car via links, so may be relevant.

- Install the active grille housing.
- Install and tighten the 3 screws.
  Torque : 7 Nm
- Install the 2 retainers.
- Install the right horn.
- Install and tighten the nut.
  Torque : 25 Nm
- Install the 2 wiring harness clips.
- Connect the electrical connector.
- Install the left horn.
- Install and tighten the nut.
  Torque : 25 Nm
- Install the wiring harness clip.
- Install the Cruise Control Module (CCM).
- Install and tighten the 2 screws.
  Torque : 9 Nm
- Connect the 2 electrical connectors.
- Install the 2 wiring harness clips.
NOTE: Repeat this step for the other side.
- Install the air duct.
- Install the 2 retainers.
Install the front bumper.
Refer to: FRONT BUMPER - INGENIUM I4 2.0L DIESEL AJ21/INGENIUM I4 2.0L PETROL/INGENIUM I4 2.0L PETROL - PHEV/INGENIUM I6 3.0L DIESEL/INGENIUM I6 3.0L PETROL .