LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2021 >> F-Pace Base >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Rear Disc Brake - V6 S/C 3.0L Petrol/INGENIUM I4 2.0L Diesel -- F-Pace (X761) >> Rear Disc Brake (G1842107) >> Removal And Installation >> Brake Disc - V8 S/C 5.0L Petrol (G2264158) >> Removal

Brake Disc - V8 S/C 5.0L Petrol (G2264158): Removal

WARNING:
  • Brake discs must be renewed in axle sets.
  • Do not use compressed air to clean brake components. Dust from friction materials can be harmful if inhaled.
CAUTION: Take care not to contaminate the brake pad friction materials or the brake discs.
NOTE:
  • This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
  • This procedure contains illustrations showing certain components removed to provide extra clarity.
  • This procedure contains illustrations for right side components, left side components are similar.
  1. If this component is being renewed because of a customer complaint, make sure to follow the brake system Diagnosis and Testing procedure.

    Refer to: BRAKE SYSTEM

  2. Connect the Jaguar Land Rover (JLR) approved diagnostic equipment and set the Electric Park Brake (EPB) to the maintenance position.

    General Equipment: Jaguar Land Rover approved diagnostic equipment 

  3. NOTE: This step is only required if the diagnostic equipment is not available.

    Set the EPB to the maintenance position.

    Refer to: ELECTRIC PARK BRAKE SERVICE MODE ACTIVATION AND DEACTIVATION

  4. NOTE: This step is only required if the vehicle has no startup battery power.

    Release the EPB.

    Refer to: ELECTRIC PARK BRAKE RELEASE WHEN THE VEHICLE HAS NO ELECTRICAL ROWER (G1822068)

  5. Disconnect the startup battery ground cable.

    Refer to: STARTUP BATTERY DISCONNECT AND CONNECT

  6. Raise and support the vehicle on a suitable 2 post lift.

    Refer to: LIFTING

  7. Remove the wheel and tire assembly.

    Refer to: WHEEL AND TIRE - V8 S/C 5.0L PETROL

  8. NOTE: The brake pad wear sensor installed on the right side only.
    G13903111Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
    • Disconnect the electrical connector from the EPB actuator.
    • Release the brake pad wear sensor.
    • Release the 2 grommets.
  9. CAUTION: Make sure that the brake hose does not support the full weight of the brake caliper assembly.
    G13903129Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
    • Remove and discard the 2 bolts.
    • Use a suitable cable tie to hold the caliper.
  10. G13903130Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
    • Remove and discard the bolt.
    • Remove the brake disc.
scientia non olet · About LEMON Manuals