Brake Disc - INGENIUM I4 2.0L Diesel/INGENIUM I4 2.0L Petrol/TDV6 3.0L Diesel/V6 S/C 3.0L RETROL (G1822057): Removal

CAUTION: Brake discs must be renewed in axle sets.

NOTE: Removal steps in this procedure may contain installation details.

If this component is being renewed because of a customer complaint, make sure to follow the brake system Diagnosis and Testing procedure.
Refer to: BRAKE SYSTEM
Connect the diagnostic tool and set the electronic park brake (EPB) to the maintenance position.
NOTE: This step is only required if the diagnostic tool is not available.

Refer to: ELECTRIC PARK BRAKE SERVICE MODE ACTIVATION AND DEACTIVATION
NOTE: This step is only required if the vehicle has no battery power.

Refer to: ELECTRIC PARK BRAKE RELEASE WHEN THE VEHICLE HAS NO ELECTRICAL ROWER (G1822068)
WARNING: Make sure to support the vehicle with axle stands.

Raise and support the vehicle.
Refer to: WHEEL AND TIRE - INGENIUM I4 2.0L DIESEL/INGENIUM I4 2.0L PETROL/TDV6 3.0L DIESEL/V6 S/C 3.0L RETROL (G1967109)
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
CAUTION:
- Make sure that the brake hose does not support the full weight of the brake caliper assembly.
- Discard the bolts.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Tie aside with a suitable tie strap.

Renew Part: Brake caliper carrier bolt(s) Quantity: 2 .

Torque

Stage 1: 70 Nm

Stage 2: 120°
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Torque: 35 Nm