Brake Pads - INGENIUM I4 2.0L Diesel (G1822046): Removal

WARNING:

Brake pads must be renewed in axle sets only. Failure to follow this instruction may result in braking efficiency being impaired.
If the brake pad wear warning light has been activated, a new brake pad wear sensor must be installed.

If this component is being renewed because of a customer complaint, make sure to follow the brake system Diagnosis and Testing procedure.
Refer to: BRAKE SYSTEM .
WARNING: Make sure to support the vehicle with axle stands.

Raise and support the vehicle.
Remove the front wheels and tires.
Refer to: REAR SUSPENSION - INGENIUM I4 2.0L DIESEL/INGENIUM I4 2.0L PETROL/TDV6 3.0L DIESEL/V6 S/C 3.0L PETROL
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
NOTE: The brake pad wear indicator sensor is easily damaged. Do not use a lever to remove the sensor. Use fingers only.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Inspect the brake pad wear sensor for signs of wear or damage. Install a new sensor if necessary.
CAUTION: Do not allow the brake caliper to hang on the brake hose.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Tie aside.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC